Avaya S8700 Maintenance Manual page 65

Avaya s8700 media server for ip connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

MEDPROPT (TN802/TN2302 MED PRO DSP PORT)
Port Status Query Test (#1407)
This test is nondestructive
This test queries the Port status.
Table 8-326. port Status Query Test (#1407)
Error
Test
Code
Result
Description / Recommendation
1
ABORT
This port is Out of service (OOS) due to:
2
ABORT
This port has been made maintenance busy
1002
ABORT
The system could not allocate timeslots for the test. The system may be
under heavy traffic conditions, or it may have timeslots out of service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
2. If the system has TDM-BUS errors, clear any errors, and retry the
3. If the command continues to abort, escalate the problem.
2000
ABORT
Response to the test was not received in the allowable time period.
1. Retry the command at 1-minute intervals up to 3 times.
2100
ABORT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500
ABORT
Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
FAIL
Unable to get status for this port. Verify that this board has been
administered correctly, and that there are no alarms against this board.
PASS
The board is functioning properly and the port is in-service and available.
0
NO
No board was detected by the test.
BOARD
1. Resolve either wrong board (Error 125) or no board (Error 131) issues, if
2. Check that the board is properly translated and inserted. If so, check for
3. Run the test again. If it fails, replace the board and retest.
555-233-142
A board-level problem, for example no IP address has been translated for
this location.
A DSP hardware problem (See
and
''DSP Capacity Query Test
retry the command at 1-minute intervals up to 3 times.
command at 1-minute intervals up to 3 times.
applicable.
hyperactivity (Error 1538). If hyperactive, use the reset board UUCSS
command.
''TDM NIC Loop-Around Test (#1380)''
(#1382)''.
Continued on next page
Issue 1 May 2002
8-761

Advertisement

Table of Contents
loading

Table of Contents