Avaya S8700 Maintenance Manual page 670

Maintenance Object Repair Procedure
Table 8-568. Test #1100 VC Summer Port Local TDM Loop-Back Test
Error Test
Code Result Description / Recommendation
1000 ABORT System resources required to run this test are not available, or the port may be
busy with a valid call.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test. The traffic load on the
system is very high, or time slots are out-of-service due to TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
1003 ABORT The system could not allocate a Tone Detector for the test, the system is
oversized for the number of Tone Detectors present, or some Tone Detectors
are out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals up to 5
1004 ABORT The port has been seized by a user for a valid call. Use the status station
command for the station associated with this port to determine whether the port
is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test request was not received from the VC-BD circuit pack
within the allowable time period.
1. If this result occurs repeatedly, reset the circuit pack if the other ports are
2. If this result occurs again, replace the circuit pack.
2012 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2103 ABORT The system could not make the conference connection for the test.
1. Retry the command at 1-minute intervals up to 5 times.
0 FAIL The TDM Loop-Around test failed.
1 FAIL The Conference Circuit test failed.
1. Replace circuit pack.
PASS The VC Summer Port Local TDM Loopback test passed.
8-1366 Issue 1 May 2002
retry the command at 1-minute intervals up to 5 times.
times.
idle. Reset the circuit pack by issuing the busyout board UUCSS and the
reset board UUCSS commands.
Continued on next page
555-233-142