Avaya S8700 Maintenance Manual page 35

MAPD-BD (MAPD Interface Circuit Pack TN802)
g. Error Type 513: transient hardware problem.
Aux Data:
4352
4353
4355
1. If the same Error Type/Aux Data value occurs more than once in a
If the MAPD board detects only one of these hardware problems, then the
error is resolved when none of these faults are detected for 10 minutes.
h. Error Type 514—LAN External RAM Error; hardware fault in the PPE
external RAM, used for message buffering to and from the packet bus.
This error should not occur regularly.
1. If this error occurs 10 times within 30 minutes, replace the circuit
i. Error Type 769—Transmit FIFO Underflow (threshold is 3 errors within 10
minutes); the circuit pack cannot find the "end of frame" bit when
transmitting a frame to the packet bus.
1. Clear the alarm using the following command sequence:
2. If the error recurs within 10 minutes, replace the circuit pack. See
j. Error Type 770—Unable to Write LAN Translation RAM (threshold is 2
errors within 10 minutes); a call is aborted because there are no available
translation RAM locations for the call connection attempt.
1. Clear the alarm using the following command sequence:
2. If the error recurs within 10 minutes, replace the circuit pack. See
555-233-142
External RAM failure
Internal RAM failure
Internal ROM failure
24-hour period, the circuit pack should be replaced. See
Down NT on the TN802''
pack. See ''Shutting Down NT on the TN802''
circuit pack.
a. busyout board UUCSS
b. reset board UUCSS
c. test board UUCSS long clear
d. release board UUCSS
''Shutting Down NT on the TN802''
a. busyout board UUCSS
b. reset board UUCSS
c. test board UUCSS long clear
d. release board UUCSS
''Shutting Down NT on the TN802''
before removing the circuit pack.
before removing the
before removing the circuit pack.
before removing the circuit pack.
Issue 1 May 2002
''Shutting
8-731