Avaya S8700 Maintenance Manual page 532

Maintenance Object Repair Procedure
Notes:
a. Error Type 1 — Indicates that the circuit pack has totally stopped
functioning or is not fully administered. The alarm is logged about
15 minutes after the circuit pack has been removed or 11 minutes after the
SAKI test (#53) fails.
To be fully administered, a UDS1 circuit pack must meet all three of the
following conditions:
1. Have an entry in the circuit plan using the change circuit pack
2. Be administered using the add ds1 UUCSS command
3. Be physically inserted into the correct slot
If the circuit pack has an entry in the circuit plan and either of the other two
conditions are not met, a MINOR alarm is logged. To resolve the error
either:
1. Make sure that every condition for administration is met and that a
2. Completely remove the UDS1-BD from the system using the
If every administration condition is met for this circuit pack and the red LED
is still on, follow the instructions for LED Alarms with Error Type 1 in
Chapter 7.
b. Error Type 18 — The UDS1 Interface circuit pack has been busied out by
a busyout board UUCSS command.
c. Error Type 23 — The UDS1-BD circuit pack is not completely
administered. To be fully administered, the UDS1 circuit pack must:
1. Have an entry in the circuit plan using the change circuit pack
2. Be administered using the add ds1 UUCSS command
3. Be physically inserted into the correct slot
A DS1 (UDS1-BD and DS1-BD) differs from most circuit packs in that
inserting the circuit pack into the switch is not enough to make the board
usable. It must also be administered with the add ds1 command.
8-1228 Issue 1 May 2002
command
functioning UDS1 circuit pack is inserted in the correct slot, or
following steps:
a. Remove any administered DS1 trunks, access endpoints or
PRI endpoints associated with the circuit pack from their
trunk groups.
b. Execute the remove ds1 UUCSS and change circuit pack
UUCSS commands.
command
555-233-142