Avaya S8700 Maintenance Manual page 72

Maintenance Object Repair Procedure
Table 8-329. Test #6 NPE Crosstalk Test — Continued
Error Test
Code Result Description / Recommendation
1018 ABORT Test disabled via administration. This only applies to analog stations. The
default for this field is y, so you may want to determine why it has been turned
off on this station.
1. To enable the test for the particular analog station being tested, enter the
2000 ABORT Response to the test request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
2020 ABORT The test did not run due to an already existing error on the specific port or a
more general circuit pack error.
1. Examine Error Log for existing errors against this port or the circuit pack
2100 ABORT System resources required to run this test are not available. This could be due
to a failure to seize the port.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL This test can fail due to on-board or off-board problems. Off-board problems of
concern include RMC-ENV faults, TDM-BUS faults, and faults associated with
the tone detectors/tone generators. Clear every off-board problem before
replacing the board. Keep in mind that a TDM-BUS problem is usually the
result of a faulty board connected to the backplane or bent pins on the
backplane.
1. Resolve any RMC-ENV errors.
2. Resolve any TDM-BUS errors.
3. Resolve any TONE-BD and/or TONE-PT errors.
4. Test the board when the faults from steps 1, 2, and 3 are cleared. Replace
8-768 Issue 1 May 2002
change station extension command and change the
'Station' form from 'n' to 'y.'
and attempt to diagnose the already existing error.
the board only if the test fails.
Test field on the
Continued on next page
555-233-142