Csu Repeater Loopback Test - Avaya S8700 Maintenance Manual

UDS1-BD (UDS1 Interface Circuit Pack)
CSU Repeater Loop-Back Test (#1211)
This test is destructive.
The CSU Repeater Loopback (RLB) test causes a loopback at the far-edge of the
local 120A1 CSU module and tests the connection from the DS1 board to and
including the CSU module circuitry. This test is only performed if the 120A1 CSU
module is present, administered, and connected to a 1.544-Mbps DS1 circuit pack
behind the port carrier.
The test is destructive and can only be initiated by a technician-demanded test
ds1-loop UUCSS ds1/csu-loopback-tests command.
Every trunk or port on the UDS1 Interface circuit pack must be busied out using
the system technician busyout board command before running the RLB test.
When the RLB test is initiated, maintenance software sends an appropriate
message to the UDS1 Interface circuit pack to start the test. The board sets up
the RLB loopback, transmits a test pattern, and verifies that the pattern is received
unaltered through the loopback. If the transmitted and received pattern is
different, the test fails.
When the test is complete, every trunk or port on the UDS1 Interface circuit pack
is restored to the in-service state after the release board command is entered.
Table 8-537. Test #1211 CSU Repeater Loop-Back Test
Error Test
Code Result Description / Recommendation
ABORT Internal system error
1. Retry the test ds1-loop UUCSS ds1/csu-loopback-tests command at
1005 ABORT CSU Repeater Loopback test cannot be executed in the current configuration.
To run this test, the
administration form must be set to
the DS1 Circuit Pack administration form must be set to
configuration).
1. Use the change ds1 UUCSS command to set the
2. Retry the test ds1-loop UUCSS ds1/csu-loopback-tests command.
555-233-142
1-minute intervals up to 5 times.
Near-End CSU Type
Type field on the DS1 Circuit Pack administration form to
integrated , and/or change the
is to be used in 24-channel configuration.
field on the DS1Circuit Pack
integrated and the Bit Rate
1.544
Near-End CSU
Bit Rate field to 1.544
Continued on next page
Issue 1 May 2002
field on
(24-channel
if the board
8-1285