Avaya S8700 Maintenance Manual page 127

M/T-ANL (Maintenance/Test Analog Port)
System Technician-Demanded Tests:
Descriptions and Error Codes
Always investigate tests in the order presented in the following table when
inspecting errors in the system. For example, by clearing error codes associated
with the Analog Port Sanity test (#963), you may also clear errors generated from
other tests in the testing sequence.
Order of Investigation
Analog Port Sanity test (#963)
Digital Loop-around test (#13)
NPE Crosstalk test (#9)
Hook State Inquiry (#566)
Clear Error Counters (#270)
1. D = Destructive, ND = Nondestructive
NPE Crosstalk Test (#9)
The NPE Crosstalk test verifies that this port's NPE channel talks on the selected
time slot and never crosses over to time slots reserved for other connections.
One or more Network Processing Elements (NPE) reside on each circuit pack
with a TDM-bus interface. The NPE controls port connectivity, gain, and provides
conferencing functions on a per-port basis. If the NPE is not working correctly,
one-way and/or noisy connections may be observed. This test is part of a port's
long test sequence and takes approximately 10 to 20 seconds to complete.
555-233-142
Short Test Long Test
Sequence Sequence
X X
X X
X
X X
X
Issue 1 May 2002
1
D/ND
ND
ND
ND
ND
ND
8-823