Configuring The Switch Module; Configuring Commonly Used Commands - H3C BX1020B IB Manual

Configuring the switch module

To configure the BX1020B switch module, you must access the operating system of the blade
enclosure where the IB mezzanine network adapter resides. Before configuring the switch module,
verify the following information:
•
The IB mezzanine network adapter is in position and has been installed with the most recent
driver.
•
The IP address of the IB mezzanine network adapter has been configured, and enable the
subnet manager.
•
The MFT tool has been installed on the blade enclosure where the IB mezzanine network
adapter resides.
For more information, see "Prerequisites" in H3C UniServer BX1020B IB Switch Module
Configuration Guide.

Configuring commonly used commands

For more information, see "Common commands for IB switch module (BX1020B)" in H3C UniServer
BX1020B IB Switch Module Configuration Guide.
1