Brocade Communications Systems Brocade 8/12c Command Reference Manual page 720

22
portCfgShow
-i index1[-index2]
-slot slot1[-slot2]
ge_port
Use portCfgShow with a GbE port or with one of the optional arguments to display specific FCIP-related
parameters.
Displays supported on the Brocade 7800/FX8-24 and on the Brocade FR4-18i platforms
The following operands are optional; if omitted, all of the configuration settings are displayed on the
FR4-18i platforms, along with the FCIP tunnels. When issued on the Brocade 7800/FX8-24, tunnels and
parameters not applicable to these platforms are not displayed. Use the portShow command to display
FCIP tunnel and circuit parameters on the Brocade 7800/FX8-24.
ipif
iproute
arp
vlantag
fciptunnel
686
Specifies a port or a range of ports identified by port index numbers. You can
specify multiple index ranges separated by a space, for example, -i 33-38 40-60.
-f
Ignores nonexisting ports. This operand is valid only with the -i option.
Specifies a slot or a range of slots. You can specify multiple slot ranges separated
by a space, for example,-s 1-3 5-7.
Specifies the number of the GbE Port to be displayed. The GbE ports are
numbered ge0 - ge9 on the Brocade FX8-24 blade and ge0 - ge5 on the Brocade
7800 switch. The 10GbE ports on the Brocade FX8-24 blade are numbered xge0
and xge1. The GbE ports on the Brocade FR4-18i are numbered ge0 and ge1.
Use the switchShow command for a list of valid ports.
Displays the IP interface for both ports of the tunnel. IPv6 addresses are
supported.
Displays the IP route on the specified GbE port. IPv6 addresses are supported.
Displays the address resolution protocol (ARP) table.
Displays the VLAN tagging configuration. For each entry, the output displays the
IP interface address, the destination IP address, the VLAN ID, and the L2 CoS
priority. This display includes permanent entries only. Permanent entries are
configured at the IP interface level with the portCfg vlantag command. To view
VLAN tagged tunnels and circuits along with permanent entries, use the
portShow vlantag command.
Displays FCIP tunnels and related parameters. Valid arguments for fciptunnel
include the following:
all
Displays information for all FCIP tunnels.
ve_port
Displays information for the specified FCIP tunnel on the Brocade 7800/FX8-24
(only). To display the tunnel, specify the VE_Port number associated with the
tunnel configured on one of the GbE ports. VE_Ports are numbered 16-23 on the
Brocade 7800 and 12-31 on the Brocade FX8-24 blade.
tunnel_id
Displays information for the specified FCIP tunnel on the Brocade FR4-18i only.
valid tunnel IDs are 0 to 7.
Fabric OS Command Reference
53-1001764-01