Configuring Telnet With Ipv6; Snmp Over Ipv6; Showing Ipv6 Information - Dell S4820T Configuration Manual

Hide thumbs Also See for S4820T:

Table of Contents

– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port

information.

– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

– For a port channel interface, enter the keywords port-channel then a number.

– For a Null interface, enter the keyword null then the Null interface number.

– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Configuring Telnet with IPv6

The Telnet client and server in Dell Networking OS supports IPv6 connections. You can establish a Telnet

session directly to the router using an IPv6 Telnet client, or you can initiate an IPv6 Telnet connection

from the router.

NOTE: Telnet to link local addresses is supported on the S4820T.

Enter the IPv6 Address for the device.

EXEC mode or EXEC Privileged mode

telnet [vrf vrf-name] ipv6 address

– ipv6 address: x:x:x:x::x

– mask: prefix length is from 0 to 128.

NOTE: IPv6 addresses are normally written as eight groups of four hexadecimal digits, where

each group is separated by a colon (:). Omitting zeros is accepted as described in Addressing.

You can configure SNMP over IPv6 transport so that an IPv6 host can perform SNMP queries and receive

SNMP notifications from a device running Dell Networking OS IPv6. The Dell Networking OS SNMP-

server commands for IPv6 have been extended to support IPv6. For more information regarding SNMP

commands, refer to the SNMP and SYSLOG chapters in the Dell Networking OS Command Line Interface

Reference Guide.

snmp-server host

snmp-server user ipv6

snmp-server community ipv6

snmp-server community access-list-name ipv6

snmp-server group ipv6

snmp-server group access-list-name ipv6

View specific IPv6 configuration with the following commands.

List the IPv6 show options.

EXEC mode or EXEC Privileged mode

IPv6 Routing