Configuring Telnet With Ipv6; Snmp Over Ipv6; Displaying Ipv6 Information - Dell S4048–ON Configuration Manual

Configuring Telnet with IPv6

The Telnet client and server in Dell Networking OS supports IPv6 connections. You can establish a Telnet session directly to the router
using an IPv6 Telnet client, or you can initiate an IPv6 Telnet connection from the router.
NOTE: Telnet to link local addresses is supported on the system.
• Enter the IPv6 Address for the device.
EXEC mode or EXEC Privileged mode
telnet [vrf vrf-name] ipv6 address
• ipv6 address: x:x:x:x::x
• mask: prefix length is from 0 to 128.
NOTE: IPv6 addresses are normally written as eight groups of four hexadecimal digits, where each group is separated by a
colon (:). Omitting zeros is accepted as described in Addressing.

SNMP over IPv6

You can configure SNMP over IPv6 transport so that an IPv6 host can perform SNMP queries and receive SNMP notifications from a
device running Dell Networking OS IPv6. The Dell Networking OS SNMP-server commands for IPv6 have been extended to support IPv6.
For more information regarding SNMP commands, refer to the SNMP and SYSLOG chapters in the Dell Networking OS Command Line
Interface Reference Guide.
•
snmp-server host
•
snmp-server user ipv6
•
snmp-server community ipv6
•
snmp-server community access-list-name ipv6
•
snmp-server group ipv6
•
snmp-server group access-list-name ipv6

Displaying IPv6 Information

View specific IPv6 configuration with the following commands.
• List the IPv6 show options.
EXEC mode or EXEC Privileged mode
show ipv6 ?
Example of show ipv6 Command Options
Dell#show ipv6 ?
accounting IPv6 accounting information
cam IPv6 CAM Entries
fib IPv6 FIB Entries
interface IPv6 interface information
mbgproutes MBGP routing table
mld MLD information
mroute IPv6 multicast-routing table
neighbors IPv6 neighbor information
ospf OSPF information
pim PIM V6 information
464 IPv6 Routing