Dell PowerConnect B-RX Configuration Manual page 1409

Commands
always-compare-med
as-path-filter <num> permit | deny <as-path>
as-path-ignore
clear ip bgp damping [<ip-addr> <ip-mask>]
clear ip bgp flap-statistics [regular-expression
<regular-expression> | <address> <mask> | neighbor
<ip-addr>]
clear ip bgp neighbor <ip-addr> [soft in prefix-filter]
clear ip bgp neighbor <ip-addr> | <peer-group-name> soft
in
clear ip bgp neighbor all | <ip-addr> | <peer-group-name>
| <as-num> [soft-outbound | soft [in | out]]
clear ip bgp neighbor all | <ip-addr> | <peer-group-name>
| <as-num> traffic
clear ip bgp neighbor all | <ip-addr> | <peer-group-name>
| <as-num>
last-packet-with-error | notification-errors
clear ip bgp routes [<ip-addr>/<prefix-length>]
clear ip bgp traffic
client-to-client-reflection
cluster-id <num> | <ip-addr>
community-filter <num> permit | deny <num>:<num> |
internet | local-as | no-advertise | no-export
compare-routerid
always-compare-med
confederation identifier <num>
confederation peers <num>
[<num> ...]
dampening [<half-life> <reuse> <suppress>
<max-suppress-time>]
default-information-originate
default-local-preference <num>
default-metric <num>
BigIron RX Series Configuration Guide
53-1002253-01
See ...
"Configuring the device to always compare MEDs"
page 759
"Defining an AS-path filter" on page 753
"Disabling or re-enabling comparison of the AS-path
length" on page 760
"Removing route dampening from a route"
page 814
"Removing route flap dampening"
"Clearing route flap dampening statistics"
page 816
"Clearing route flap dampening statistics"
page 823
"Sending and receiving ORFs"
"Placing a policy change into effect"
"Dynamically refreshing routes"
"Clearing traffic counters" on page 822
"Clearing diagnostic buffers" on page 824
"Clearing and resetting BGP4 routes in the IP route
table" on page 822
"Clearing traffic counters" on page 822
"Disabling or re-enabling client-to-client route
reflection" on page 761
"Configuring a route reflector"
"Configuration procedures" on page 794
"Defining a community filter" on page 753
"Enabling or disabling comparison of the router IDs"
on page 761
"Configuring the device to always compare MEDs"
page 759
"Configuring a BGP confederation"
"Configuring a BGP confederation"
"Configuring route flap dampening"
"Originating the default route"
"Changing the default local preference"
"Changing the default metric used for redistribution"
on page 766
E
BGP4
on
on
on page 823
on
on
on page 810
on page 817
on page 819
on page 761
on
on page 763
on page 763
on page 765
on page 765
on page 766
1333