Dell PowerConnect B-RX Configuration Manual page 1433

Commands
area <num> | <ip-addr> virtual-link <ip-addr>
[authentication-key [0 | 1] <string>] [dead-interval
<num>] [hello-interval <num>] [md5-authentication
key-activation-wait-time <num> | key-id <num> [0 | 1] key
<string>] [retransmit-interval <num>] [transmit-delay
<num>]
area <num> | <ip-addr> virtual-link <router-id>
[authentication-key | dead-interval | hello-interval |
retransmit-interval | transmit-delay <value> |
[md5-authentication key-activation-wait-time <num> |
key-id <num> [0 | 1] key <string>]
area <num> | <ip-addr>
auto-cost reference-bandwidth <num>
database-overflow-interval <value>
default-information-originate [always] [metric <value>]
[metric-type <type>]
default-metric <value>
distance external | inter-area | intra-area <distance>
ip ospf area <ip-addr>
ip ospf auth-change-wait-time <secs>
ip ospf database-filter all out
log all | adjacency | bad_packet [checksum] | database |
memory | retransmit
metric-type type1 | type2
redistribution bgp | connected | rip | [isis level-1|
level-1-2| level-2] | static [route-map <map-name>]
rfc1583-compatibility
router ospf
show ip ospf area
[<area-id>] | [<num>]
show ip ospf border-routers
[<ip-addr>]
show ip ospf config
show ip ospf database external-link-state [advertise
<num>] | [extensive] | [link-state-id <ip-addr>] | [router-id
<ip-addr>] | [sequence-number <num(Hex)>] | [status
<num>]
BigIron RX Series Configuration Guide
53-1002253-01
OSPF version 4
See ...
"Modify virtual link parameters"
"Assign virtual links" on page 695
"Assign OSPF areas" on page 687
"Changing the reference bandwidth"
"Modify exit overflow interval"
"Configure default route origination"
"Modify default metric for redistribution"
page 704
"Modify administrative distance"
"Assigning interfaces to an area"
"Change the timer for OSPF authentication changes"
on page 694
"Block flooding of outbound LSAs on specific OSPF
interfaces" on page 695
"Specify types of OSPF Syslog messages to log"
page 719
"Modify redistribution metric type"
"Enable route redistribution" on page 705
"Define redistribution filters" on page 703
"Modify OSPF standard compliance setting"
page 718
"Enable OSPF on the router" on page 687
"Displaying OSPF area information"
"Displaying OSPF ABR and ASBR information"
page 731
"Configure external route summarization"
page 708
"Displaying general OSPF configuration information"
on page 720
"Displaying OSPF external link state Information"
page 729
E
on page 697
on page 703
on page 719
on page 709
on
on page 712
on page 691
on
on page 711
on
on page 723
on
on
on
1357