Dell PowerConnect B-RX Configuration Manual page 1394

A
Syslog messages
TABLE 228
Message level
Informational
Informational
Informational
Informational
Informational
Informational
Debug
Debug
TABLE 229
Message level
Notification
Notification
Notification
1318
Brocade Syslog messages (Continued)
Message
ACL <acl id> added | deleted | modified from
console | telnet | ssh | web | snmp session
SNMP read-only community | read-write
community | contact | location | user |
group | view | engineld | trap [host] [<value
-str>] deleted | added | modified from
console | telnet | ssh | web | snmp session
Syslog server <IP-address> deleted | added |
modified from console | telnet | ssh | web |
snmp
OR
Syslog operation enabled | disabled from
console | telnet | ssh | web | snmp
SSH | telnet server enabled | disabled from
console | telnet | ssh | web | snmp session
[by user <username>]
Enable super | port-config | read-only
password deleted | added | modified from
console | telnet | ssh | web | snmp
OR
Line password deleted | added | modified
from console | telnet | ssh | web | snmp
Port <portnum>, srcip-security
max-ipaddr-per-int reached.Last IP=<ipaddr>
BGP4: Not enough memory available to run
BGP4
DOT1X: Not enough memory
BFD Syslog messages
Message
BFD: Session UP for NBR <neighbor-ID> on
<port>
BFD: Session DOWN for NBR
<neighbor-ID> on <port> Reason:
Neighbor Signaled Session Down
BFD: Session DOWN for NBR
<neighbor-ID> on <port> Reason:
Administratively Down
Explanation
A user created, modified, deleted, or applied
an ACL through the Web, SNMP, console,
SSH, or Telnet session.
A user made SNMP configuration changes
through the Web, SNMP, console, SSH, or
Telnet session.
[<value-str>] does not appear in the message
if SNMP community or engineld is specified.
A user made Syslog configuration changes to
the specified Syslog server address, or
enabled or disabled a Syslog operation
through the Web, SNMP, console, SSH, or
Telnet session.
A user enabled or disabled an SSH or Telnet
session, or changed the SSH enable/disable
configuration through the Web, SNMP,
console, SSH, or Telnet session.
A user created, re-configured, or deleted an
Enable or Line password through the Web,
SNMP, console, SSH, or Telnet session.
The address limit specified by the
srcip-security max-ipaddr-per-interface
command has been reached for the port.
The device could not start the BGP4 routing
protocol because there is not enough
memory available.
There is not enough system memory for
802.1x authentication to take place. Contact
Brocade Technical Support.
Explanation
The BFD session is UP with the neighbor
specified by the <neighbor-ID> on the port
specified by the <port> variable.
The BFD session with the neighbor
specified by the <neighbor-ID> on the port
specified by the <port> variable is Down
because the BFD neighbor has signaled the
session to be down.
The BFD session with the neighbor
specified by the <neighbor-ID> on the port
specified by the <port> variable is Down for
Administrative reasons.
BigIron RX Series Configuration Guide
53-1002253-01