Dell PowerConnect B-RX Configuration Manual page 1341

This field...
priority
age
Displaying multicast neighbor information
To display information about the device's IPv6 PIM neighbors, enter the following command at any
CLI level.
BigIron RX#show ipv6 pim nbr
Port Phy_Port Neighbor
e11/15 e11/15 fe80::45:27:49:4
v312
BigIron RX#
Syntax: show ipv6 pim nbr
This display shows the following information.
This field...
Port
Neighbor
Phy_Port
Holdtime sec
Age sec
UpTime sec
Displaying the IPv6 PIM multicast cache
To display the IPv6 PIM multicast cache, enter the following command at any CLI level.
BigIron RX Series Configuration Guide
53-1002253-01
Displays...
The RP priority of the candidate RP. During the election process, the candidate
RP with the highest priority is elected as the RP.
The age (in seconds) of this RP-set.
NOTE: If this device is not a BSR, this field contains zero. Only the BSR ages the
e11/3 fe80::45:27:1:2
Displays...
The interface through which the device is connected to the neighbor.
The IPv6 interface of the IPv6 PIM neighbor interface.
Indicates how many seconds the neighbor wants this device to hold the entry for
this neighbor in memory. The neighbor sends the Hold Time in its Hello packets.
•
If the device receives a new Hello packet before the Hold Time received in
the previous packet expires, the device updates its table entry for the
neighbor.
•
If the device does not receive a new Hello packet from the neighbor before
the Hold time expires, the device assumes the neighbor is no longer
available and removes the entry for the neighbor.
The number of seconds since the device received the last hello message from the
neighbor.
The number of seconds the PIM neighbor has been up. This timer starts when
the device receives the first Hello messages from the neighbor.
RP-set.
IPv6 PIM sparse
Holdtime Age UpTime
sec sec sec
105 20 1010
105 10 1900
49
1265