Dell PowerConnect B-RX Configuration Manual page 1368

A
Configuring the Syslog service
TABLE 227
This field...
Syslog logging
messages dropped
flushes
overruns
level
messages logged
level code
Static and dynamic buffers
The software provides two separate buffers:
•
•
In either the static or dynamic log, new messages replace older ones; only the most recent
message is displayed. For example, only the most recent temperature warning message will be
present in the logs. If multiple temperature warning messages are sent to the logs, the latest one
replaces the previous one.
Contents of both the static and dynamic buffers are displayed when you issue the show logging
command.
1292
CLI display of Syslog buffer configuration
Static – logs power supply failures, fan failures, and temperature warning or shutdown
messages.
Dynamic – logs all other message types. Also, an entry in the static log triggers an entry in the
dynamic log. The dynamic log buffer can store up to 3800 messages.
Displays...
The state (enabled or disabled) of the Syslog buffer.
The number of Syslog messages dropped due to user-configured filters.
By default, the software logs messages for all Syslog levels. You can
disable individual Syslog levels, in which case the software filters out
messages at those levels. Refer to
level" on page 1296. Each time the software filters out a Syslog
message, this counter is incremented.
The number of times the Syslog buffer has been cleared by the clear
logging command. Refer to "Clearing log entries"
The number of times the dynamic log buffer has filled up and been
cleared to hold new entries. For example, if the buffer is set for 100
entries, the 101st entry causes an overrun. After that, the 201st entry
causes a second overrun.
The message levels that are enabled. Each letter represents a message
type and is identified by the key (level code) below the value. If you
disable logging of a message level, the code for that level is not listed.
The total number of messages that have been logged since the software
was loaded.
The message levels represented by the one-letter codes.
"Disabling logging of a message
on page 1293.
BigIron RX Series Configuration Guide
53-1002253-01