Dell PowerConnect B-RX Configuration Manual page 1379

TABLE 228
Message level
Notification
Notification
Notification
Notification
Notification
Notification
Notification
BigIron RX Series Configuration Guide
53-1002253-01
Brocade Syslog messages (Continued)
Message
Module was inserted to slot <slot-num>
Module was removed from slot <slot-num>
ACL insufficient L4 session resource, using
flow based ACL instead
ACL exceed max DMA L4 cam resource, using
flow based ACL instead
ACL insufficient L4 cam resource, using flow
based ACL instead
ACL system fragment packet inspect rate
<rate> exceeded
ACL port fragment packet inspect rate <rate>
exceeded on port <portnum>
Syslog messages
Explanation
Indicates that a module was inserted into a
device slot.
The <slot-num> is the number of the device
slot into which the module was inserted.
Indicates that a module was removed from a
device slot.
The <slot-num> is the number of the device
slot from which the module was removed.
The device does not have enough Layer 4
session entries.
To correct this condition, allocate more
memory for sessions. To allocate more
memory, enter the following command at the
global CONFIG level of the CLI interface.
system-max session-limit <num>
The port does not have enough Layer 4 CAM
entries for the ACL.
To correct this condition, allocate more Layer
4 CAM entries. To allocate more Layer 4 CAM
entries, enter the following command at the
CLI configuration level for the interface.
ip access-group max-l4-cam <num>
The port does not have a large enough CAM
partition for the ACLs.
The fragment rate allowed on the device has
been exceeded.
The <rate> indicates the maximum rate
allowed.
This message can occur if fragment thottling
is enabled.
The fragment rate allowed on an individual
interface has been exceeded.
The <rate> indicates the maximum rate
allowed.
The <portnum> indicates the port.
This message can occur if fragment thottling
is enabled.
A
1303