Quality Of Service (Qos) - Dell PowerConnect B-RX Configuration Manual

Quality of Service (QoS)

Commands
dscp <num>
priority <num>
qos multicast best-effort rate <rate>
qos queue-type <queue-number> wred averaging-weight
<avg-weight>
qos queue-type <queue-number> wred drop-precedence
<policing-status> drop-probability-max
<p-max>
qos queue-type <queue-number> wred drop-precedence
<policing-status> max-avg-queue-size <max-size>
qos queue-type <queue-number> wred drop-precedence
<policing-status> min-avg-queue-size <min-size>
qos queue-type <queue-number> max-queue-size
<max-queue>
qos queue-type <queue-number> wred drop-precedence
<policing-status> packet-size-max <pkt-size>
qos queue-type <queue-number> wred enable
qos scheduler destination-weighted <queue0-weight>
<queue1-weight> <queue2-weight> <queue3-weight>
qos scheduler enhanced-strict <queue0-rate>
<queue1-rate> <queue2-rate> <queue3-rate>
qos scheduler max-rate <queue0-rate> <queue1-rate>
<queue2-rate> <queue3-rate>
qos scheduler min-rate <queue0-rate> <queue1-rate>
<queue2-rate> <queue3-rate>
qos scheduler source-weighted <queue0-weight>
<queue1-weight> <queue2-weight> <queue3-weight>
qos scheduler strict
qos-tos map cos-dscp <dscp0> <dscp1> <dscp2>
<dscp3> <dscp4> <dscp5> <dscp6> <dscp7>
qos-tos map cos-priority <prio0>
<prio1><prio2><prio3><prio4><prio5><prio6> <prio7>
qos-tos map dscp-dscp <old-dscp-value>
[<old-dscp-value>...]
to <new-dscp-value>
qos-tos map dscp-priority <dscp-value> [<dscp-value> ...]
to <priority>
qos-tos mark cos | dscp
BigIron RX Series Configuration Guide
53-1001810-01
Quality of Service (QoS)
See ...
"Configuring DSCP classification by interface"
page 468
"Changing a port's priority" on page 469
"Changing a Layer 2 port-based VLAN's priority"
page 469
"Configuring multicast traffic engineering"
page 486
"Setting the averaging-weight (Wq) parameter"
page 478
"Setting the maximum drop probability"
"Setting the minimum and maximum average queue
size" on page 479
"Setting the minimum and maximum average queue
size" on page 479
"Configuring the maximum instantaneous queue
size" on page 479
"Setting the maximum packet size"
"Enabling WRED" on page 477
"Configuring WFQ destination-based traffic
scheduling" on page 484
"Configuring enhanced strict priority-based traffic
scheduling" on page 483
"Configuring maximum rate-based traffic scheduling"
on page 485
"Configuring minimum rate-based traffic scheduling"
on page 485
"Configuring WFQ source-based traffic scheduling"
on page 484
"Configuring strict priority-based traffic scheduling"
on page 483
"Changing the CoS –> DSCP mappings"
"Changing the DSCP –> internal forwarding priority
mappings" on page 472
"Changing the DSCP –> DSCP mappings"
page 472
"Changing the DSCP –> internal forwarding priority
mappings" on page 472
"Enabling marking" on page 471
E
on
on
on
on
on page 479
on page 480
on page 471
on
1341