Dell PowerConnect B-RX Configuration Manual page 1381

Commands That Require a Reload
Most CLI commands take effect as soon as you enter them. However, a small number of
commands require a software reload to take effect.
To place a configuration change made by one of these commands into effect, you must save the
change to the startup-config file, then reload the software. If you reload the software without
saving the change to the startup-config file, the device does not make the change.
To reload the software, you must perform a cold start. To perform a cold start, do one of the
following:
•
•
NOTE
The boot system command does not perform a cold start. It performs a warm start.
TABLE 225
Command
max-frame-size
system-max
BigIron RX Series Configuration Guide
53-1001810-01
Enter the reload command at the Privileged EXEC level of the CLI.
Cycle the power by powering down the device, then powering it on again.
Commands that require a software reload
Table 225
See ...
"Setting maximum frame size per PPCR"
"Displaying and modifying system parameter default settings"
page 127
lists the commands.
on page 172
on
Appendix
D
1309