E
Port-based routing
Commands
ip address <ip-addr> <ip-mask> | <ip-addr>/<mask-bits>
lock-address ethernet <portnum> [addr-count <num>]
monitor
ethe-port-monitored <portnum> | named-port-monitored
<portname> ethernet | <portnum>
in | out | both
phy-mode wan
port-name <text>
qd-flow sink <sinking-threshold> sunk <sunk-threshold>
slot <slot>
set mirror-interface
<slot number>/<port number>
show monitor actual
show monitor config
speed-duplex <value>
Port-based routing
Commands
access-list <num> deny | permit <source-ip> |
<hostname> <wildcard>
access-list <num> deny | permit
<source-ip>/<mask-bits> | <hostname>
access-list <num> deny | permit any
access-list <num> deny | permit host <source-ip> |
<hostname>
ip policy route-map <map-name>
match ip address
<ACL-num-or-name>
route-map <map-name>
permit | deny <num>
set interface null0
set ip next hop <ip-addr>
1340
See ...
"Assigning an IP address to a port"
"Locking a port to restrict addresses"
"Monitoring an individual trunk port"
"Enabling WAN PHY mode support"
"Assigning a port name"
on page 133
"Specifying threshold values for flow control"
page 137
"Configuring mirror ports for PBR traffic"
page 143
"Displaying mirror and monitor port configuration"
page 144
"Displaying mirror and monitor port configuration"
page 144
"Speed/Duplex negotiation"
on page 134
See ...
"Configure the ACLs"
on page 564
"Enabling PBR"
on page 566
"Configure the route map"
on page 566
"Configure the route map"
on page 566
"Basic example"
on page 567
"Configure the route map"
on page 566
"Configure the route map"
on page 566
"Basic example"
on page 567
BigIron RX Series Configuration Guide
on page 134
on page 137
on page 142
on page 144
on
on
on
on
53-1001810-01