Displaying Arp Entries - Dell PowerConnect B-FCXs Configuration Manual

26
Displaying IP configuration information and statistics
TABLE 160
This field...
Method
Status
Protocol
To display detailed IP information for a specific interface, enter a command such as the following.
PowerConnect# show ip interface ethernet 1/1
Interface Ethernet 1/1
port state: UP
ip address: 192.168.9.51
encapsulation: ETHERNET, mtu: 1500, metric: 1
directed-broadcast-forwarding: disabled
proxy-arp: disabled
ip arp-age:
Ip Flow switching is disabled
No Helper Addresses are configured.
No inbound ip access-list is set
No outgoing ip access-list is set

Displaying ARP entries

You can display the ARP cache and the static ARP table. The ARP cache contains entries for
devices attached to the Layer 3 Switch. The static ARP table contains the user-configured ARP
entries. An entry in the static ARP table enters the ARP cache when the entry interface comes up.
The tables require separate display commands or Web management options.
Displaying the ARP cache
To display the contents of the ARP cache, enter the following command at any CLI level.
PowerConnect# show arp
Total number of ARP entries: 5, maximum capacity: 6000
No.
1
2
3
4
5
Syntax: show arp [ethernet [<slotnum>/]<portnum> | mac-address <xxxx.xxxx.xxxx> [<mask>] |
The <slotnum> parameter is required on chassis devices.
The <portnum> parameter lets you restrict the display to entries for a specific port.
874
CLI display of interface IP configuration information (Continued)
Displays...
Whether the IP address has been saved in NVRAM. If you have set the IP address for the
interface in the CLI or Web Management Interface, but have not saved the configuration, the
entry for the interface in the Method field is "manual".
The link status of the interface. If you have disabled the interface with the disable command,
the entry in the Status field will be "administratively down". Otherwise, the entry in the Status
field will be either "up" or "down".
Whether the interface can provide two-way communication. If the IP address is configured, and
the link status of the interface is up, the entry in the protocol field will be "up". Otherwise the
entry in the protocol field will be "down".
10 minutes
IP Address MAC Address
207.95.6.102 0800.5afc.ea21
207.95.6.18 00a0.24d2.04ed
207.95.6.54 00a0.24ab.cd2b
207.95.6.101 0800.207c.a7fa
207.95.6.211 00c0.2638.ac9c
<ip-addr> [<ip-mask>]] [<num>]
subnet mask: 255.255.255.0
Type
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
PowerConnect B-Series FCX Configuration Guide
Age Port Status
0 6 Valid
3 6 Pend
0 6 Pend
0 6 Valid
0 6 Valid
53-1002266-01