Patton electronics SmartNode Series Software Configuration Manual page 24

About this guide
• Chapter 3, "Command line interface (CLI)"
that allow you to navigate the CLI and edit commands effectively.
• Chapter 4, "Accessing the CLI"
the command line interface (CLI), to obtain help, to change operator mode and to terminate a session.
• Chapter 5, "Establishing basic IP connectivity"
nections to and from your SmartNode by using IP interfaces and Ethernet ports.
• Chapter 6, "System image handling"
driver software.
• Chapter 7, "Configuration file handling"
files from and to a SmartNode 1000, 2000, or 4000 Series devices.
• Chapter 8, "Basic system management"
tion to the operator or administrator, and their configuration.
• Chapter 9, "Radius Client Configuration"
rization, and accounting (AAA) component in SmartWare and describes how to configure the Radius client,
a subpart of the AAA component.
• Chapter 10, "IP context overview"
with its related components.
• Chapter 11, "IP interface configuration"
and describes the tasks involved in their configuration.
• Chapter 12, "NAT/NAPT configuration"
port translation and describes the tasks involved in its configuration.
• Chapter 13, "Ethernet port configuration"
describes the tasks involved in their configuration through SmartWare.
• Chapter 14, "Link scheduler configuration"
quality of service (QoS) features.
• Chapter 15, "Serial port configuration"
the tasks involved in its configuration through SmartWare.
• Chapter 16, "Basic IP routing configuration"
the tasks involved in configuring static IP routing in SmartWare.
• Chapter 17, "RIP configuration"
(RIP) and describes the tasks involved in configuring RIP features within SmartWare.
• Chapter 18, "Access control list configuration"
and describes the tasks involved in their configuration through SmartWare.
• Chapter 19, "SNMP configuration"
management protocol (SNMP) and describes the tasks used to configure those of its features supported by
SmartWare.
• Chapter 20, "SNTP client configuration"
tocol (SNTP) client.
22
on page 41 gives an overview of the CLI and the basic features
on page 47 describes the procedures for entering SmartWare commands via
on page 57 explains how to establish network-based con-
on page 65 describes how to load and maintain system images and
on page 81 describes how to upload and download configuration
on page 95 describes parameters that report basic system informa-
on page 107 provides an overview of the authentication, autho-
on page 117 outlines SmartWare Internet protocol (IP) context, together
on page 125 provides a general overview of SmartNode interfaces
on page 133 provides a general overview of the network address
on page 141 provides an overview of Ethernet ports and
on page 151 describes how to use and configure SmartWare
on page 169 provides an overview of the serial port and describes
on page 187 provides an overview of IP routing and describes
on page 193 provides an overview of the routing information protocol
on page 203 provides an overview of IP access control lists
on page 217 provides overview information about the simple network
on page 233 describes how to configure a simple network time pro-
SmartWare Software Configuration Guide