SmartWare Software Configuration Guide
[no] address-translation incoming-call called-name
{(fix <value> ) | to-header }
[no] use profile voip <profile>
[no] use profile tone-set <profile>
exit
interface_isdn
[no] interface isdn
[no] route {call} {(dest-table ) | (dest-interface ) | (dest-service ) }
[no] use mapping-table {in|out}
[no] dtmf-dialing
[no] use profile pstn
[no] use profile tone-set <profile>
[no] call-waiting
[no] isdn-date-time
exit
interface_fxs
[no] interface fxs
[no] route {call} {(dest-table ) | (dest-interface ) | (dest-service ) }
[no] use mapping-table {in|out}
[no] use mapping-table {precall-service}
[no] call-hold
[no] call-waiting
[no] additional-call-offering
[no] call-transfer
[no] caller-id-presentation {pre-ring|mid-ring}
[no] subscriber-number <number>
[no] use profile tone-set <profile>
[no] use profile pstn
exit
interface_fxo
[no] interface fxo
[no] route {call|precall} {(dest-table ) | (dest-interface ) | (dest-service
) }
[no] use mapping-table {in|out}
[no] use mapping-table {precall-service}
[no] disconnect-signal {battery-reversal|loop-break|busy-tone}
[no] connect-signal {battery-reversal|tax-pulse}
ring-number <number>
dial-after {dialtone | (timeout <seconds> ) }
[no] use profile tone-set <profile>
[no] use profile pstn
exit
service_hunt
[no] service hunt-group
[no] cyclic
[no] timeout <timeout>
[no] drop-cause
[no] route {call} [<index> ] {(dest-table ) | (dest-interface ) | (dest-
service ) }
exit
Contexts and interfaces
C • Command summary
539
Need help?
Do you have a question about the SmartNode Series and is the answer not in the manual?