Enabling The Early Call Disconnect (Optional) - Patton electronics SmartNode Series Software Configuration Manual

31 • H.323 interface configuration
Mode: Interface H.323
Step
1
node ( if- h323 )[ if-name ]#clip-clir-support Enables CLIP/CLIR support on the H.323
Example: Enable CLIP/CLIR support
The following example shows how to enable CLIP/CLIR support on the H.323 interface MyH323If.
SN>enable
SN#configure
SN(cfg)#context cs
SN(ctx-cs)[switch]#interface h323 MyH323If
SN(if-h323)[MyH323If]#clip-clir-support

Enabling the early call disconnect (optional)

Early call disconnect suppresses busy tones (e.g. disturbing a telephone conference) and post-call announce-
ments by sending an H.323 Release message to the remote peer when the connected terminal hangs up (ISDN:
when Disconnect message is received; analog line: when busy tone is detected, loop current is interrupted, or
battery voltage is reversed).
Procedure: To enable early call disconnect
Mode: Interface H.323
Step
1
node (if-h323)[ if-name ]#early-disconnect
Example: Enable early call disconnect
The following example shows how to enable early call disconnect on an H.323 interface named MyH323If.
SN>enable
SN#configure
SN(cfg)#context cs
SN(ctx-cs)[switch]#interface h323 MyH323If
SN(if-h323)[MyH323If]#early-disconnect
352
Command
Command
SmartWare Software Configuration Guide
Purpose
interface
Purpose
Enables early call disconnect (Default: dis-
abled)
H.323 interface configuration task list