Patton electronics SmartNode Series Software Configuration Manual page 503

SmartWare Software Configuration Guide
18:34:10 ICC
Bearer capability : speech - CCITT
circuit mode - 64kBit/s - G.711 A-law
Calling party number : 60
unknown number - unknown numbering plan
presentation allowed - user provided not screened
Called party number : 50
unknown number - E.164 numbering plan
High layer compatibility : telephony
CCITT
18:34:10 ICC
18:34:10 ICC
18:34:10 ICC
18:34:10 ICC
18:34:10 ICC
18:34:10 ICC
18:34:10 ICC
Progress indicator : inband information available
private network serving local user - CCITT
18:34:18 ICC
18:34:18 ICC
18:34:18 ICC
Connected number : 50
unknown number - E.164 numbering plan
presentation allowed - user provided not screened
Explanation:
• The terminal places the call using en-bloc sending (no overlap dialing). In the log, this is represented by the
lines "
18:34:10 ICC
there is a message coming from ISDN (represented by "<<" towards the left). ISDN layer1, 2 and 3 work
correctly in this case.
• If the SETUP message does not appear, one of the lower ISDN layers doesn't work. Verify ISDN port status
using the "show port isdn" command (see chapter 35,
"debug isdn events" commands (see below).
• The SETUP message contains different elements, among others the calling party number (60), and the
called party number (50). Verify these (depending on your application, there might be as well other ele-
ments in the message).
• The line "
18:34:10
dialed number is alerting now. The ALERTING message is sent back to the terminal (represented by ">>"
towards the right). You can be sure now that context CS functionality is working.
• The line "
18:34:18
call is now established. The called party has answered the call.
• If instead of the ALERTING, a RELEASE or DISCONNECT message appears, continue debugging the
outgoing call on the destination signaling protocol and the call-router.
Debugging call signaling
> [TERMINAL-00b73348] << SETUP (DSS1 Ntwk)
> [TERMINAL-00b73348] State: NULL, Event: TERMINAL SETUP IND
> [TERMINAL-00b73348] Set state to OVERLAP SENDING
> [TERMINAL-00b73348] >> SETUP ACKNOWLEDGEMENT (DSS1 Ntwk)
> [TERMINAL-00b73348] State: OVERLAP SENDING, Event: PEER TRYING
> [TERMINAL-00b73348] State: OVERLAP SENDING, Event: PEER ALERTING
> [TERMINAL-00b73348] Set state to CALL DELIVERED
> [TERMINAL-00b73348] >> ALERTING (DSS1 Ntwk)
> [TERMINAL-00b73348] State: CALL DELIVERED, Event: PEER CONNECTED
> [TERMINAL-00b73348] Set state to ACTIVE
> [TERMINAL-00b73348] >> CONNECT (DSS1 Ntwk)
> [TERMINAL-00b73348] << SETUP (DSS1 Ntwk)
ICC > [TERMINAL-00b73348] >> ALERTING (DSS1 Ntwk)
ICC > [TERMINAL-00b73348] >> CONNECT (DSS1 Ntwk)
"ISDN port configuration"
42 • VoIP debugging
and below. This means
on page 425), and the
" shows that the
" indicates that the
501