Debugging H.323 Signaling - Patton electronics SmartNode Series Software Configuration Manual

42 • VoIP debugging
09:14:02 FXS
09:14:02 FXS
09:14:02 CFXS
09:14:02 CFXS
09:14:02 FXS
09:14:02 FXS
09:14:02 CFXS
Explanation:
• "
unit(cfg)#09:13:55 CFXS > [EP PHONE] Change state to RINGING.
changes the state to RINGING, that means it has accepted the call.
• "
09:13:55 FXS
This means that the binding of the port to the context CS interface is correct, and your phone should now
be ringing.
• If the phone does not start to ring, revise the binding of the port to the context CS interface, and the con-
nectors of the POTS line.
• "
09:14:02 CFXS
accepted the call. The state of the CS interface goes to CONNECTED. The call is now established.

Debugging H.323 Signaling

Overview: H.323 debug monitors
unit #debug gateway h323 signaling
unit #debug gateway h323 error
unit #debug gateway h323 datapath
unit #show gateway h323 status
unit #show gateway h323 call name
[detail detail ]
unit #show call-control provider name
[detail detail ]
ee also section "Troubleshooting"
S
than 40 debug monitors, such as 'q931', 'ras' or 'signaling'. For a list of all available debug monitors, refer to
the CLI online help.
506
> [0 1] Set state to 'Active'
> FXS-00/01: new state=off-hook
> [EP PHONE] Change state to CONNECTED.
> [EP PHONE] Stop ring.
> FXS-00/01: state=off-hook, event=ring-stop
> FXS-00/01: new state=off-hook
> [EP PHONE] Change datapath direction to send/receive.
> [0 1] Set state to 'Ringing'
> [EP PHONE] Change state to CONNECTED.
Command
on page 463 for further informations on debugging H.323. There are more
SmartWare Software Configuration Guide
": The port begins to ring on the analog line.
": The phone went off-hook and thus
Purpose
Prints all signaling operations on H.323 interfaces.
General purpose error monitor of H.323. Always
enable this when debugging H.323.
Prints operations on the H.323 part of the voice
data path. Use this monitor if you experience prob-
lems in the data path (no speech connectivity,
speech only in one direction). This monitor is not
needed to debug signaling.
Shows the state of the H.323 gateway. Among
others: enabled/disabled, RAS registration state.
Shows all calls ongoing on the H.323 interface on
context CS with name name.
Shows the status of an H.323 interface in context
CS (call control part of H.323 signaling). Shown
are all calls currently onging on the interface, with
their call states, signaling peers and voice data
path parameters.
name is the name of the H.323 interface. Use
detail 5 for most verbose output.
": The context CS interface
Debugging call signaling