About this guide
The objective of this SmartWare Command Configuration Guide is to provide information concerning the syn-
tax and usage of the command set. For hardware configuration information, refer to the getting started guide
that came with your SmartNode systems.
This section describes the following:
•
Who should use this guide (see "Audience")
•
How this document is organized (see "Structure")
•
Typographical conventions and terms used in this guide (see
ment"
on page 25)
Audience
This guide is intended for the following users:
•
System administrators who are responsible for installing and configuring networking equipment and who
are familiar with the SmartNode.
•
System administrators with a basic networking background and experience, but who might not be familiar
with the SmartNode.
•
Operators
•
Installers
•
Maintenance technicians
How to read this guide
SmartWare is a complex and multifaceted operating system running on your SmartNode device. Without the
necessary theoretical background you will not be able to understand and use all the features available. There-
fore, we recommend reading at least the chapters listed below to get a general idea about SmartWare and the
philosophy of contexts used for IP and circuit switching related configuration.
•
Appendix A,
"Terms and definitions"
throughout this SmartWare Software Configuration Guide
•
Chapter 1,
"System overview"
tem.
•
Chapter 10,
"IP context overview"
•
Chapter 26,
"CS context overview"
Structure
This guide contains the following chapters and appendices:
•
Chapter 1,
"System overview"
•
Chapter 2,
"Configuration concepts"
on page 517 contains the terms and their definitions that are used
on page 27 provides an overview of the main elements of a SmartNode sys-
on page 117
on page 293
on page 27 provides an overview of the main elements of a SmartNode system.
on page 35 introduces basic SmartWare configuration concepts.
"Typographical conventions used in this docu-
21
Need help?
Do you have a question about the SmartNode Series and is the answer not in the manual?