Deleting Call Services; Activate The Call Router Configuration - Patton electronics SmartNode Series Software Configuration Manual

33 • Call router configuration
Note It does not make sense to configure the maximum number of concurrent
destinations but no timeout, though the software does not prevent this con-
figuration.

Deleting call services

To remove individual call services you can use the no form of the service command.
Procedure: To delete a call service
Mode: Context CS
Step Command
1 node (ctx-cs)[ switch ]#no service service-
name
Example: Remove an entire mapping table
SN(cfg)#context cs
SN(ctx-cs)[switch]#no service HUNT-BRI
Activate the call router configuration
Prior to activate the call router configuration you can show the whole context CS configuration and the entire
call routing tables.
The call router configuration is activated as soon as the CS context comes out of shutdown (e.g. at boot time or
by manually entering command no shutdown). You can modify the configuration at runtime; changes will be
active after 3 seconds. SmartWare offers a number of possibilities to monitor and debug the CS context and
call router configurations. For more information refer to chapter 42,
Note
It is not necessary to shutdown the CS context prior to making any configu-
ration changes.
Procedure: To show and activate the call router configuration
408
SmartWare Software Configuration Guide
Delete the service service-name .
You do not have to enter the type of the service when
Note:
just deleting it. The type must only be specified when creating
a service.
"VoIP debugging"
Purpose
on page 497.
Call router configuration task list