Patton electronics SmartNode Series Software Configuration Manual page 90

7 • Configuration file handling
Example: Replacing the startup configuration with a configuration from Flash memory
The following example shows how to replace the persistent startup configuration in the flash memory of a
SmartNode by overwriting it with the configuration in the file new-startup stored in flash memory.
1. Replace the current startup configuration, by using the copy command, into the flash memory area where
the startup configuration is stored.
SN#copy nvram:new-startup startup-config
2. Check the content of the persistent startup configuration by listing its command settings with the show
command.
SN#show startup-config
Startup configuration:
#----------------------------------------#
# SmartWare R3.10 BUILD24128 #
# 2001-10-25T09:20:42
# Generated configuration file
#----------------------------------------#
cli version 3.00
snmp community public rw
framerelay
exit
SN#
88
SmartWare Software Configuration Guide
#
#
Configuration file handling task list