Check Network Connection To Remote System; Load A Program To Memory, So That It Can Be Executed Or Stored In The Flash Memory - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide

Check network connection to remote system

Step 1 ping [-v] [-n count ] [-l length ]
[-t timeout ] [-r rate ] [-i IP_addr ess]
-h IP_address
Load a program to memory, so that it can be executed or stored in the Flash
memory
Step 1 load [-r] [-v] [-h host ] [-m various ]
[-c channel ] [-b base_address ]
file_name
Other
Command
Command
Purpose
Check network connection to a remote system, by
sending ICMP echo requests and listening for ICMP
echo replies.
-v: Verbose mode, shows extra information.
-n: Number of pings to send (Default: 10)
-l: Length of request to send in bytes (Default: 64).
-t: Time to wait for a response (Default: 1000mS).
-r: Rate at which requests are sent in milliseconds.
For example, 20 = 50 requests per seconds
(Default: 1000mS)
-i: The IP address RedBoot should use (Default:
value set by ip_address)
-h: Host to ping.
Purpose
Loads a program via TFTP, X- or Y-modem (serial
port) to memory.
-r: Selects raw or ELF data mode. Use –r for firm-
ware images.
-v: Display a spinner to show progress.
-h: IP address of host to get file from (Default: value
set by ip_address)
-m: Transfer mode. One of: tftp, xmodem, ymodem.
-c: Channel to use for serial transfer (Default: 0).
-b: Address in memory to load program.
file_name: Name of program to load. Used for
TFTP transfer.
C • Command summary
551