Creating An Administrator Account - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Creating a new operator account is described in the following procedure:
Mode: Operator execution
Step
1 node> enable
2 node# configure
3 node(cfg)# operator name password password Creates a new operator account name and
4 copy running-config startup-config
Example: Create an operator account
The following example shows how to add a new operator account with a login name support and a matching
password of s4DF&qw. The changed configuration is then saved.
SN>enable
SN#configure
SN(cfg)#operator support password s4DF&qw
SN(cfg)#copy running-config startup-config

Creating an administrator account

Administrators can run the enable command and access additional information within the SmartWare config-
uration modes. Therefore administrators can modify the system configuration, as well as view all relevant sys-
tem information.
Creating a new administrator account is described in the following procedure:
Mode: Operator execution
Step
1 node >enable
2 node# configure
3 node(cfg)# administrator name password password Creates a new administrator account
4 node(cfg)# copy running-config startup-config
Example: Create an administrator account
The following example shows how to add a new administrator account with a login name super and a matching
password Gh3*Ke4h.
SN>enable
SN#configure
SN(cfg)#administrator super password Gh3*Ke4h
SN(cfg)#copy running-config startup-config
Accessing the SmartWare CLI task list
Command
Command
Purpose
Enters administration execution mode
Enters configuration mode
password password
Saves the change made to the running config-
uration of the SmartNode, so that it will be
used following a reload
Purpose
Enters administration execution mode
Enters configuration mode
name and password password
Permanently stores the new administrator
account parameters.
4 • Accessing the CLI
53