Displaying Serial Port Information - Patton electronics SmartNode Series Software Configuration Manual

15 • Serial port configuration
Mode: Administrator execution
[no] debug framerelay
[no] debug framerelay all
[no] debug framerelay error
[no] debug framerelay lmi
[no] debug framerelay management
[no] debug framerelay packets

Displaying serial port information

The following example shows the commands used to display serial port configuration settings.
SN>enable
SN#configure
SN(cfg)#show port serial
Serial Interface Configuration
-------------------------------------
Port
State
Hardware Port
Port Type
CRC Type
Max Frame Length: 2048
Recv Threshold
Encapsulation
182
Command
: serial 0 0 0
: OPENED
: X.21
: DTE
: CRC-16
: 1
: framerelay
SmartWare Software Configuration Guide
Purpose
Prints the status of the different monitors ( ON or
OFF)
Enables/Disables all framerelay debug monitors
Enables/Disables monitor which prints only
occurred errors.
Enables/Disables monitor which prints keepalive
events and messages
Enables/Disables monitor which prints management
and configuration events
Enables/Disables monitor which prints dlci, size and
fragmentation status of every incoming and outgo-
ing packet. Be aware that this monitor can seriously
impact your system performance.
Serial port configuration task list