Displaying Frame Relay Information - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide

Displaying Frame Relay information

Since Frame Relay configuration for the serial interface is complex and requires many commands, it is helpful
to list the frame relay configuration on screen.
This procedure describes how to display the Frame Relay configuration settings for the serial interface.
Mode: Port serial
Step
1 node (prt-ser)[ slot/port ]#show framerelay Displays Frame Relay information.
Example: Displaying Frame Relay information
The following example shows the commands used to display Frame Relay configuration settings.
SN>enable
SN#configure
SN(cfg)#show framerelay
Framerelay Configuration:
Port LMI-Type
----------------------------------------------------------
serial 0 0 0 ansi
PVC Configuration:
Port DLCI
--------------------------------------------------------------
serial 0 0 0 1
Serial port configuration task list
Command
Keepalive
10
State Fragment
open disabled
15 • Serial port configuration
Purpose
Fragmentation
disabled
Encaps Binding
rfc1490 wan@router
183