Isdn Port Configuration Task List; Shutdown And Enable Isdn Ports - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
4. Enter Q921 mode.
5. BRI uses point-to-multipoint topology.
6. Layer 2 user/network setting is automatically determined by layer 3 UNI-side settings.
7. Use 'q931' as layer 3 protocol.
8. Enter Q931 mode.
9. Layer 3 uses DSS1 signalling protocol.
10. Running network side part of signalling protocol.
11. Port 0/1 shall be bound to the call control.
12. The call-control interface to use is 'isdn01'.
13. Enter configuration mode for port bri 0/1.
14. Enable port.
ISDN port configuration task list
Configuring ISDN ports typically consists of the following tasks:
•

Shutdown and enable ISDN ports

• Configure ISDN layer 1 parameters for BRI ports
• Configure ISDN layer 1 parameters for PRI ports
• Configure ISDN layer 2 parameters
• Configure ISDN layer 3 parameters

Shutdown and enable ISDN ports

By default all ISDN ports are initially shutdown.
Procedure: To disable and activate an ISDN port

ISDN port configuration task list

35 • ISDN port configuration
431