Show Redboot Version; Restart System; Display Memory Content; Set Ip Addresses - Patton electronics SmartNode Series Software Configuration Manual

C • Command summary

Show RedBoot version

Step 1

Restart system

Step 1

Display memory content

Step 1 dump -b location [-l length ] [-s]
[-1|2|4]
x -b location [-l length ] [-s] [-1|2|4]

Set IP addresses

Step 1 ip_address [-l local_ip_address [/
mask_len ]] [-h server ] [-g gateway ]
550
Command
version
Command
reset
Command
Command
SmartWare Software Configuration Guide
Purpose
Shows RedBoot version.
Purpose
Restarts the system.
Purpose
Displays memory.
-b: Start of memory (default: next address).
-l: Length in bytes (default: 256).
-s: Show as S-Record.
-1: Show as bytes (8 bit).
-2: Show as words (16 bit).
-3: Show as longs (32 bit).
Purpose
Sets the IP address of Ethernet interface 0/0
-l: Local IP address and subnet mask. The subnet
mask is specified as the number of one bits in the
mask (i.e. /24 for 255.255.255.0)
-h: Server IP address. Used for TFTP download.
-g: Default gateway IP address.
Other