Numbering Plan Routing Table; Name Routing Table - Patton electronics SmartNode Series Software Configuration Manual

33 • Call router configuration

Numbering plan routing table

The calling party numbering plan or called party numbering plan (calling-number-plan or called-numbering-
plan) table is used to route calls based on the calling or called party numbering plan field in the ISDN setup
message. This can be used to differentiate calls between numbers of an ISDN, data, telex, national standard or
private numbering plan.
Note This call property is only set by incoming ISDN calls. A call that arrives the
call router from a FXS or SIP interface has a numbering plan of unknown.
The call router can route calls according to the following numbering plans. These values beside default can be
used for the key parameter to create a routing table entry:
• unknown—Unknown numbering plan. This is the default value for calls that arrive through an interface
that does not support the numbering plan property.
• isdn-telephony—ISDN/Telephony numbering plan according to CCITT Reccommendation E.164/
E.163).
• data—Data numbering plan according to CCITT Recommendation X.121.
• telex—Telex numbering plan according to CCITT Recommendation F.69.
• national-standard—Numbering plan according to a national standard.
• private—Any private numbering plan.
Example: Calling numbering-plan routing table
The following example shows how to create a routing table with name NP that routes calls based on the calling
part numbering plan. Calls with calling party numbers formed according to the ISDN/Telephony numbering
plan are routed to the next table TAB-INCOMING-ISDN, calls with calling party numbers formed according
to the data numbering plan to the next table TAB-INCOMING-DATA and all other calls to the next table
TAB-INCOMING-UNKNOWN.
SN(cfg)#context cs
SN(ctx-cs)[switch]#routing-table calling-numbering-plan NP
SN(rt-tab)[NP]#route isdn-telephony dest-table TAB-INCOMING-ISDN
SN(rt-tab)[NP]#route data dest-table TAB-INCOMING-DATA
SN(rt-tab)[NP]#route default dest-table TAB-INCOMING-UNKNOWN

Name routing table

The calling display name or called display name (calling-name or called-name) table is used to route calls based
on the human-readable name of the calling or called party. The key you specify in a routing table entry must be
identical to the display name of the calling or called party for the entry to match.
Note
Incoming SIP calls use this call property to store the display name part of the
SIP URI. Other interfaces set the display name to the empty string.
Example: Calling display name routing table
This example routes calls based on the display name part of the From-URI of an incoming SIP call.
SN(cfg)#context cs
SN(ctx-cs)[switch]#routing-table calling-name name
380
SmartWare Software Configuration Guide
Call router configuration task list