Profile_Service-Policy; Source; Profile_Napt - Patton electronics SmartNode Series Software Configuration Manual

C • Command summary
unreachable|host-unknown|host-unreachable|information-reply|information-
request|mask-reply|mask-request|mobile-redirect|net-redirect|net-tos-
redirect|net-tos-unreachable|net-unreachable|network-unknown|no-room-for-
option|option-missing|packet-too-big|parameter-problem|port-
unreachable|precedence-unreachable|protocol-unreachable|reassembly-
timeout|redirect|router-advertisement|router-solicitation|source-
quench|source-route-failed|time-exceeded|timestamp-reply|timestamp-
request|traceroute|ttl-exceeded|unreachable} type <type> type <type> code
<code> ] ) } [[tos {{max-reliability|max-throughput|min-delay|min-monetary-
cost|normal} | <tos-value> } ] [precedence {{critical|flash|flash-
override|immediate|internet|network|priority|routine} | <precedence> } ]
dscp <dscp> [mask {1|3|7|15|31} ] ] [{cos | traffic-class } <cos> {cos-rtp |
rtp-traffic-class } <cos_rtp> <cos_rtcp> ] [ipsec-policy <ipsec_policy> ]
exit
profile_service-policy
[no] profile service-policy <arbiter-name>
mode {shaper | burst-shaper | wfq | burst-wfq }
[no] rate-limit <value>
(header-length <option-value> )
atm-modem
(voice-margin <voice-margin-value> )
[no] queue-limit <value>
[no] set ip dscp <value>
[no] set ip precedence <value>
[no] set ip tos <value>
[no] set layer2 cos <value>
[no] debug queue statistics [detail <value> ]

source

[no] source {({traffic-class | class } <source-name> ) | (policy <source-
name> ) }
[no] rate {<value> | remaining }
[no] share <value>
[no] random-detect [<value> ]
[no] priority
[no] police <value> burst-size <option-value>
[no] queue-limit <value>
[no] set ip dscp <value>
[no] set ip precedence <value>
[no] set ip tos <value>
[no] set layer2 cos <value>
[no] debug queue statistics [detail <value> ]
exit
exit
profile_napt
[no] profile napt <napt-profile_name>
[no] range <local_ip1> <local_ip2> <global_ip> [<global_ip2> ]
[no] static <local_ip1> <global_ip>
[no] static {udp|tcp} <local_ip1> <local_port> [<global_ip> ] [<global_port> ]
[no] static {udp|tcp} <local_port> <local_ip1>
exit
544
SmartWare Software Configuration Guide
Profiles