Show Isdn Port Status - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Step
5
node (prt-pstn)[ slot/port ]#channel-range
min max
or
node (prt-pstn)[ slot/port ]#no channel-
range
6
node (q931)[slot/port]# bchan-number-
order ascending
or
node (q931)[slot/port]#bchan-number-
order ascending-cyclic
or
node (q931)[slot/port]#bchan-number-
order descending
or
node (q931)[slot/port]#bchan-number-
order descending-cyclic
7
node (q931)[ slot/port ]#encapsulation cc-
isdn
or
node (q931)[ slot/port ]#no encapsulation
8
node (prt-e1)[ slot/port ]#bind interface
interface

Show ISDN port status

Procedure: To display the current status of an ISDN port
ISDN port configuration task list
Command
35 • ISDN port configuration
Purpose
Specify B-channel range to be used on a PRI
port (Default: E1: 0-31, T1: 0-23)
Limits the time-slots to be used for calls to the
range between min and max . This is in some
cases required for interoperability with ISDN
services that impose the same limitations.
Call slots outside the defined range are
rejected (busy line). If no range is defined
(Default) all 30 (T1: 23) time-slots are avail-
able for use.
The no form of the command restores the
default settings.
Specify B-channel allocation strategy (Default:
ascending)
The numbering mode defines how the avail-
able time slots are filled. The cyclic modes use
a 'round-robin' implementation. The 'up' and
'down' modes define whether the time slots
are filled at the lowest or highest available
slot, i.e. 'up' means that always the lowest
available slot is used, 'down' uses always the
highest available slot.
Specify encapsulation of port.
Currently only CC-ISDN is supported.
The no form of the command removes an
existing encapsulation.
Bind port to an existing call control interface.
437