Displaying Nat/Napt Configuration Information - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Step
node (cfg)#context ip router
1
node (ctx-ip)[router]#interface
2
name
3 node (if-ip)[ name ]#use profile
napt profile
Example: Configuring NAPT Interface
The following example shows how to activate a NAT/NAPT component with the NAPT profile access on the
IP interface lan.
SN(cfg)#context ip router
SN(ctx-ip)[router]#interface lan
SN(if-ip)[lan]#use profile napt access
Displaying NAT/NAPT configuration information
Two commands are available to display an existing NAPT profile. There is no command yet to display the
dynamic entries of a NAT/NAPT component.
Procedure: To display NAT/NAPT configuration information
Mode: Configure
Step 1 node (cfg)#show profile napt
Step 2 node (cfg)#show profile napt
name
or
node (cfg)#show napt interface
name
Example: Display NAT/NAPT Configuration Information
SN(cfg)#show profile napt
NAPT profiles:
--------------
access
SN(cfg)#show profile napt access
NAPT profile access:
--------------------
ICMP default server: (none)
STATIC NAPT MAPPINGS
Protocol Local IP
-------- --------------- ----------- --------------- -----------
NAT/NAPT configuration task list
Command
Command
Local Port
Purpose
Selects the IP router context
The NAPT profile shall be used on the interface name
Defines that the NAPT profile profile shall be used on
the interface name
Purpose
Displays the available NAPT profiles
Displays the NAPT profile name
or
Displays the NAPT profile bound to the IP interface
name
Global IP Global Port
12 • NAT/NAPT configuration
139