Fxo Interface Configuration Task List; Configuring An Alternate Pstn Profile (Optional) - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
FXO interface configuration task list
There are numerous configurable parameters that apply to the FXO interface. The basic commands are listed
with a short description of their function.
• use profile pstn—Defining and applying an alternate PSTN profile for a specific FXO interface
• dial-after—Selecting whether the FXO interface dials after a pre-defined time or after detection of dial-tone
• ring-number—Defining how many rings are received before answering an incoming call
• disconnect-signal—Selecting the method of determining a call has been disconnected
• connect-signal—Choosing how to detect the connection on the remote end of an outgoing call
• route—Determining the destination (interface) for the incoming call
Configuring an alternate PSTN profile (optional)
The PSTN profile has the following configurable parameters:
• Echo canceller (can be enabled or disabled)
• Output gain, which sets the volume of the output of the PSTN interface and port, in this case, FXO.
To define an alternate PSTN profile for the FXO interface, first create the profile according to instructions in
chapter 41, "PSTN profile configuration"
a specific FXO interface with the use command as follows.
First enter the Interface FXO configuration mode.
Mode: Interface FXO
Step Prompt, command & response
1 node>
2 node>enable
node#
3 node#configure
node(cfg)#
4 node(cfg)#context cs
node(ctx-cs)[switch]#
5 node(ctx-cs)[switch]#interface fxo if-name Enter the Interface FXO configuration mode
node(if-fxo) [if-name] #

FXO interface configuration task list

on page 493. Then you can apply the newly defined PSTN profile to
Basic prompt in Operator Exec mode
Enters Administration execution mode
Response: The prompt in administration execu-
tion mode is the #
Enters the Configure configuration mode
Response: The prompt in the Configure configu-
ration mode is (cfg)#
Enters the Context CS configure mode
Response: The prompt in the Context CS configu-
ration mode is (ctx-cs)[switch]#
Response: The prompt in the Interface FXO con-
figuration mode is (if-fxo) [if-name] #
30 • FXO interface configuration
Purpose
339