Configuring And Starting The Web Server; Determining And Defining The Active Cli Version - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Operator execution
Step Command
1 node >show uptime
Example:
The following example shows how to display the uptime of your device, if you start from the configuration mode.
SN>show uptime
The system is up for 1 days, 23 hours, 44 minutes, 18 seconds
Configuring and starting the Web server
SmartNode includes an embedded web server, that can be used together with a customer-specific Java applet
that must be downloaded into the persistent memory region of your SmartNode. Applets are similar to appli-
cations but they do not run as standalones. Instead, applets adhere to a set of conventions that lets them run
within a Java-compatible browser. With a Java applet, custom-specific configuration tasks of SmartWare are
possible using a browser instead of accessing the SmartWare CLI via Telnet or the serial console.
Without a Java applet the value of the embedded web server is limited. Contact Patton Electronics Co. for any
questions about custom designed Java configuration tools for SmartWare.
Mode: Configure
Step Command
1 node (cfg)#webserver language
{ de | en }
node (cfg)#webserver port port-
2
number
Example: Configuring and starting the Web server
The following example shows how to set the web server language and the listening port of your device, if you
start from the configuration mode.
SN(cfg)#webserver language en
SN(cfg)#webserver port 80
Determining and defining the active CLI version
SmartWare allows having a number of CLI version installed together, whereas only one CLI version is acti-
vated. There are commands available to determine the currently running CLI version and if necessary switch to
another CLI version. The idea of having several CLI version available on a system is mostly to offer reduced or
enhanced command sets to users.
Mode: Configure
Step
node (cfg)#show version cli
1
Basic system management configuration task list
Display the time since last restart.
Command
Purpose
Sets the language to either German (de) or English (en).
Sets the listening port number in the 1 to 65535, default
port number for the web server is 80.
Displays the currently running CLI version
8 • Basic system management
Purpose
Purpose
101