Installation Requirements - HP Spooler FASTP Manual

Installation and Configuration Considerations for
FASTPTCP

Installation Requirements

Before the FASTPTCP print process can be installed and configured, the following
requirements must be met:

The following products must be installed and configured on your host system:

Spooler subsystem

TCP/IP subsystem

Your LAN must be installed and connected to your host system.
Note that the underlying system-product requirements of the LAN connection vary
because the network architecture is different between G-series and D-series
RVUs. For G-series RVUs, TLAM and MLMUX are obsolete. The ServerNet LAN
Systems Access Method (SLSA) subsystem has replaced TLAM.
For additional information about the installation and configuration of TCP/IP, including
any LAN requirements, consult the following manuals:

TCP/IP Configuration and Management Manual (for G- and H-series RVUs)

Parallel Library TCP/IP Configuration and Management Manual (for G-series
RVUs)

NonStop TCP/IP Configuration and Management Manual (for D-series RVUs)
Spooler FASTP Network Print Processes Manual — 427528-006
3 - 3
Installation Requirements