HP Spooler FASTP Manual page 349

EMS Messages
can only occur when the print process has been improperly started. The most likely
cause is the TACL RUN command was inadvertently used.
Effect. The FASTP network print process stops.
Recovery. Do not use TACL RUN commands for FASTP network print processes; use
the normal Spooler mechanism as described in
Process on page 2-4. If the error persists, contact your service provider as described in
Troubleshooting and Reporting Problems
512
proc-num Warning - Err: %nnnnnn from PRINTREAD
proc-num
is the process number (CPU, PIN) of the process.
%nnnnnn
is an octal return code from the PRINTREAD operation. Error codes returned by
the PRINTREAD procedure are described in the Spooler Programmer's Guide.
Cause. The FASTP network print process was attempting to extract job data for
printing when an unexpected error was returned by the Spooler PRINTREAD
procedure.
Effect. The device is placed offline.
Recovery. If the error persists, contact your service provider as described in
Troubleshooting and Reporting Problems
Spooler FASTP Network Print Processes Manual — 427528-006
Configuring a FASTP Network Print
on page 8-1.
on page 8-1.
B - 137
FASTP EMS 512 Text Messages