Example 3-2. Sample Fastcfg File For A Ttap Printer Connected Through A Telnet Terminal Server - HP Spooler FASTP Manual

Installation and Configuration Considerations for
FASTPTCP
POLLNUM = poll-number
specifies the number of times FASTPTCP polls a device while waiting for the busy
device to become free. Typically a device signals busy as a means of flow control.
When POLLNUM is exhausted, FASTPTCP reports error 100 to the Spooler
supervisor. The default value is 30.
Note. POLLINT and POLLNUM determine the interval and number of times FASTPTCP
solicits device status. Under normal circumstances, you can rely on FASTPTCP default values
for controlling the communications session. However, because TTAP connections solicit
information from the printer, the POLLINT and POLLNUM parameters are available for
customizing communications behavior. You should use these attributes carefully, and only in
special network situations where congestion or other delays are known to be affecting
FASTPTCP performance, or where job length prevents end-of-job detection.
Sample FASTCNFG File for a TTAP Printer Connected
Through a TELNET Terminal Server
Example 3-2 contains a sample FASTCNFG file for a TTAP printer connected through
a TELNET terminal server:
Example 3-2. Sample FASTCFG File for a TTAP Printer Connected Through a
TELNET Terminal Server
HOSTS $DATA2.TCPIP.HOSTS ! If not specified name / address 

DEVICE $LASER
CONTYPE = TCP/IP-TELNET
ADDRESS = Tser1
PORT = 4002
PROTOCOL = TTAP
IDLETIMEOUT = 60
Spooler FASTP Network Print Processes Manual — 427528-006
FASTCNFG DEVICE Attributes for Supported TTAP
Printers Connected Through AWAN Servers or
! resolution comes from DNS server
! 5574 via TELNET Terminal Server
! Resolved from HOSTS file or DNS 
! Identifies actual printer port
! Printer employs Tandem TTAP protocol
! Clear connection after 60 seconds
3 - 25
