HP Spooler FASTP Manual page 341

EMS Messages
512
proc-num DEV: device-name X25 Circuit Disconnect 
nnnn1 nnnn2 nnnn3 nnnn4
proc-num
is the process number (CPU, PIN) of the process.
device-name
is the Spooler device name.
nnnn1 nnn2 nnn3 nnn4
are the four reason codes returned by the SETPARAM procedure. These codes
are defined in the X25AM Programming Manual.
Cause. This message applies to FASTPX25 only. An X.25 circuit disconnect (error
140) has occurred. This message is only recorded when bit 2 (%20000) of the PARM
attribute of the Spoolcom DEV command is set.
Effect. The supervisor considers error 140 to be a retryable error and directs
FASTPX25 to retry the printing operation at the interval configured by the Spoolcom
DEV RETRY value. As a default, FASTPXNS attempts to reprint the job at the last
known correctly printed page. As a result, FASTPX25 might reprint certain pages.
Recovery. Under normal circumstances, no operator intervention is required.
However, you can modify the supervisor's response to this error by means of the
RECOVERY attribute in the FASTCNFG file. The default value is NORMAL, which
results in the behavior described above. If you set this attribute to REPRINT,
FASTPX25 returns to the first page of the job when printing is resumed.
512
proc-num DEV: device-name X25 Disconnect Cause: nnn, 
Diag: mmm
proc-num
is the process number (CPU, PIN) of the process.
device-name
is the Spooler device name.
nnn
is the contents of the cause field in the X.25 clear request packet.
Spooler FASTP Network Print Processes Manual — 427528-006
B - 129
FASTP EMS 512 Text Messages