HP Spooler FASTP Manual page 63

Installing and Configuring FASTP Network Print
Processes
Table 2-10. Supported SETMODE Functions and Parameters for FASTP Network
Print Processes (page 2 of 3)
Function Supported Parameters and Their Effects
28 Reset to configured values.
Causes the FASTP network print process to behave as though all the
following SETMODEs had been issued:
Note: A FASTP network print process does NOT issue a PCL Reset
sequence in response to this SETMODE.
142 Select character set.
The following parameter values are supported:
param1 = 1 Emit <Esc (10U> in order to select the IBM PC character
Note: Param1 applies to PCL Printers 5512, 5515, 5516, 5518, 5573,
5574 & 5577.
260 Enable PostScript printing for the FASTP network print processes.
The following parameter values are supported:
param1 = 2 Enables Intelligent PostScript. The FASTP network print
Spooler FASTP Network Print Processes Manual — 427528-006
SETMODE (5,1) Auto eject on
SETMODE (6,1,0) Auto LF and Auto CR
SETMODE (25,60) Form length 60 lines
SETMODE (27,0) Post space mode
set.
= 0 Emit <Esc (0@> in order to select the default character
set.
process emits the PJL Language command to switch the
printer to Postscript mode. The FASTP network print
process scans the job data looking for the start of a
compliant PostScript document. All data before this point is
discarded. After finding the start of the PostScript
document, the FASTP network print process scans the
data looking for embedded PostScript line breaks. If none
are found, the FASTP network print process assumes a
text-mode PostScript job and adds suitable line breaks at
the record boundaries. If the FASTP network print process
finds line breaks in the data, it assumes a Binary
PostScript job.
Using the CONTROL, CONTROLBUF, and
2 - 37
SETMODE Operations