Fastcnfg Device Attributes For All Fastptcp Devices - HP Spooler FASTP Manual

Installation and Configuration Considerations for
FASTPTCP
The alternative method for specifying a hosts file is to add the following DEFINE before
starting the Spooler supervisor:
ADD DEFINE =HOSTS , FILE hosts-file-name
where
hosts-file-name
specifies the name of the local file to be used for address resolution if the
ADDRESS is a host name.
Note, if both a DEFINE and a FASTCNFG HOSTS entry are used, the FASTCNFG
HOSTS entry overrides the DEFINE.

FASTCNFG DEVICE Attributes for All FASTPTCP Devices

The following attributes can be specified for any FASTPTCP device. Note that some of
these attributes (such as CONTYPE, PROTOCOL, ADDRESS, and PORT) are usually
required for most FASTPTCP devices, whereas the remainder of these attributes
(BLOCK, TIMEOUT, TCP/IP-A, TCP/IP-B, and IDLETIMEOUT) are optional and offer
additional site-customization features. The basic syntax for DEVICE entries for all
FASTPTCP printers is as follows:
DEVICE device-name
CONTYPE = {TCP/IP|TCP/IP-TELNET} !Required for
PROTOCOL = {NONE |
ADDRESS = {ip-addess | hostname} !Required
PORT = ip-port
BLOCK = blocksize
IDLETIMEOUT = idle-timeout
SHADOW = shadow-file-name
SHADOW2 = shadow-file-name2
SHADOW3 = shadow-file-name3
SHADOW4 = shadow-file-name4
SHADOW5 = shadow-file-name5
SHADOW6 = shadow-file-name6
SHADOW7 = shadow-file-name7
SHADOW8 = shadow-file-name8
TCP/IP-A = primary-process-name
TCP/IP-B = backup-process-name
TIMEOUT = io-timeout

Spooler FASTP Network Print Processes Manual — 427528-006

TTAP |
HPJETDIRECT |
LPD1179 |
LEXMARK |
MICROPLEX}
3 - 15
FASTCNFG DEVICE Attributes for All FASTPTCP
!TCP/IP TELNET
!Required for TTAP
!Required for HPJETDIRECT
!Required for LPD1179
!Required for LEXMARK 
!Required for MICROPLEX
!Required for NONE
!and TTAP protocols
!Optional
!Optional
!Optional
!Optional
!Optional
!Optional
!Optional
!Optional
!Optional
!Optional
!Optional
!Optional
!Optional
Devices