HP Spooler FASTP Manual page 170

Installation and Configuration Considerations for
FASTPX25
If FASTPX25 cannot find an X25NUA value in FASTCNFG, it expects the
DESTADDR value to have been configured for the corresponding X25AM
subdevice.
NOINVITATION = (YES|NO}
specifies whether FASTPX25 sends an INVITATION TO CLEAR command.
FASTPX25 attempts to ensure print job delivery by sending an INVITATION TO
CLEAR to initiate call clearing. The values are:
YES
specifies FASTPX25 will not send an INVITATION TO CLEAR command; use
this value when the PAD does not support the INVITATION TO CLEAR
command.
NO
specifies FASTPX25 sends an INVITATION TO CLEAR command. The default
value is NO.
RECOVERY = {NORMAL|REPRINT}
specifies the recovery behavior to be used by FASTPX25 following Guardian error
122 or 140. Normally when FASTPX25 encounters either error 122 (circuit reset) or
error 140 (circuit disconnect), it attempts to resume the job by returning to the last
known correctly printed page and then begins printing from that point again. This
attribute allows you to specify the option of returning to the first page and reprinting
the entire job. The values are:
NORMAL
indicates that normal recovery behavior should be invoked following Guardian
error 122 or error 140 (that is, the job should resume printing at the last known
correctly printed page). This is the default value.
REPRINT
indicates that the entire job should be reprinted following Guardian error 122 or
error 140.
SHADOW[n] = shadow-file-namen...
is a required attribute if tracing is enabled (that is, if bit 1 (%40000) of the PARM
attribute is set using the Spoolcom DEV command). Each value specified defines
the Guardian file name of a Guardian file used for trace output. If a file name is not
fully qualified, the volume and subvolume name default to the volume and
subvolume where the object code for the FASTPX25 print process resides. From 1
to 8 trace files can be defined.
Tracing is discussed in
Spooler FASTP Network Print Processes Manual — 427528-006
Section 8, Troubleshooting and Using the Trace
6 - 14
Optional DEVICE Attributes for FASTPX25
Facility.