Table of Contents
Advertisement
Installation, Configuration, and Usage
Considerations for FASTPXNS
Installation and Configuration Tasks for
FASTPXNS
To install and configure a FASTPXNS print process, perform the following tasks:
1. Install the FASTPXNS object code ($SYSTEM.SYSTEM.FASTPXNS) This step is
described in
2. Add the following configuration information to a Spooler subsystem either
interactively or in a command file:
a. Create one or more FASTPXNS print processes using the Spoolcom PRINT
command. Creation of a print process is described in step
Configuration Tasks
b. Associate each device name (that is, the device name designated for an Xerox
printer) with the appropriate FASTPXNS print process and specify the
appropriate spooler device attributes for each device using the Spoolcom DEV
command.
A FASTPXNS print process supports a maximum of 32 Xerox printers.
General use of the DEV command is described in step
Configuration Tasks
and device attributes for XNS printers is discussed in
Considerations for FASTPXNS
c. Designate one or more Spooler job locations for each Xerox printer and
associate each one with the appropriate device name using the Spoolcom JOB
command. Designation of a spooler job location is described in step
Spooler Configuration Tasks
3. Create a FASTCNFG file to contain network protocol and transport parameters for
the devices. The creation of a FASTCNFG file is discussed in general terms in
Configuring a FASTCNFG File
XNS printers are discussed in
on page 7-11.
Spooler FASTP Network Print Processes Manual — 427528-006
Installing a FASTP Network Print Process
on page 2-14.
on page 2-14. The specification of spooler device names
on page 2-14.
on page 2-17. FASTCNFG DEVICE attributes for
FASTCNFG DEVICE Configuration For FASTPXNS
Installation and Configuration Tasks for FASTPXNS
on page 2-2.
on page 7-8.
7 - 7
2
of
Spooler
3
of
Spooler
Spooler Configuration
4
of
Advertisement
Table of Contents
Troubleshooting
