HP Spooler FASTP Manual page 305

EMS Messages
Recovery. Either remove the SVCMACRO attribute from the FASTCNFG file or add a
MACRO entry to the FASTCNFG file and restart the Spooler device. (Depending on the
device configuration, the device might restart automatically.)
512
proc-num DEV: device-name MBCS Conflict - Using SETMODE 144
value mmmm instead of CHARMAP nnnn
proc-num
is the process number (CPU, PIN) of the process.
device-name
is the Spooler device name.
mmmm
is the value returned by the SETMODE 144 call.
nnnn
is the CHARMAP conversion value specified using the Spoolcom DEV command in
the Spooler configuration.
Cause. This error applies to SNAX devices only. The FASTP network print process
detected a conflict between the CHARMAP conversion value specified in the Spooler
configuration and the value returned by the Guardian SETMODE 144 call.
Effect. The FASTP network print process uses the SETMODE 144 value in place of
the value specified by the CHARMAP parameter.
Recovery. If the error persists, contact your service provider as described in
Troubleshooting and Reporting Problems
512
proc-num DEV: device-name MBCS Substitute Shift to DBCS
string too long, Job: job-num
proc-num
is the process number (CPU, PIN) of the process.
device-name
is the Spooler device name.
Spooler FASTP Network Print Processes Manual — 427528-006
on page 8-1.
B - 93
FASTP EMS 512 Text Messages